Larssevsk
If there was a silicone ring, there would be steam around the lid. If there was something with the valve, the pressure would not have accumulated in 5 minutes. Some kind of cosmic figure. For 3 years, I have never gained pressure in such a time. Try to drive it on the water and see from what place the steam is coming down, if it really comes down so hard, then it's very difficult not to notice where it comes from
Chit
Larssevsk, Larisa, thank you very much for your advice, I will definitely use it. And just drive it out again with water in the same mode and with the same parameters?
P.S. Itself surprised by the short time of pressure build-up, usually it is much more. The water was poured warm, not hot, 2 tbsp.
Knor
I had something similar:
Quote: Chubby

A terrible thing happened to me today! I put vegetables on the program, the cartoon began to gain pressure, and the valve spat. Then cotton and how the steam will fall from under the lid ...
I changed the ring immediately.
Larssevsk
Well, it means the warm water built up pressure so quickly. Run on the porridge the same amount of water as the first time. Remove the child from the kitchen and take a closer look. From this we will dance
Chit
Oppa, a similar situation. True, the plug did not spit, and after turning it off, it banged. I'll try to change the ring. Thank you.
Margo31
Here I have to pick it up today, and now I don’t know what to do. Pick up 6L can see everything well or immediately re-order dd2 5L. But I already so want to take her
Girls, help !!! Brains are already boiling !!! DD2 5L fewer problems or whoever is lucky? Maybe 6L somehow did not finish?
No, I'm lucky today, I'll pick up my Shtebochka
Chit
Girls, don't panic! Shtebochka is smart, before that there were no "shots". I cooked buckwheat today for the first time, somehow it still doesn't work. By the way, it turned out to be Bombovskaya, large, boiled grains, juicy. I haven't eaten this for a long time.
beverli
Chit, and how much did you use it?
Chit
Quote: beverli

Chit, and how much did you use it?
I have it for six months, most often I cook millet, corn on "porridge". Today I decided to buckwheat in a shtebochka, we are sitting with the child at home on sick leave.
Don't be upset ahead of time! this is my case.
beverli
Chit, but not only you succeed, the girls over there write that it was also like this
Chit
Quote: beverli

Chit, but not only you succeed, the girls over there write that it was also like this
We will think of something, we will solve this issue. Because of this, there is no need to give up on Shteba, she is good.
beverli
Chit, I don't give up)) I want to understand why this is happening and how to avoid it, that's all) otherwise misunderstanding of the situation drives you into a stupor
Knor
Margarita, mine banged after a couple of weeks of use, put a ring from the unit and have been cooking on it since summer. So far, everything is fine. 5 liters. Now, of course, I would take 6
Masinen
Girls, what a panic, I can't understand. Everything happens, here most likely the ring moved out, so she let off steam and that's it)
Margo31
It is no coincidence that on ozone 6L is cheaper than 5L. Or am I already finding fault
Masha, in the next topic, the temperature can not stand
Masinen
Yulia, no need to look for a catch where it is not)
beverli
Mashul, uraaaa, you came and now you will calm us down)))) Is this possible only because of the ring?
Masinen
Yes, the ring is to blame.
Chit
Quote: Chubby

Margarita, mine banged after a couple of weeks of use, put a ring from the unit and have been cooking on it since summer. So far, everything is fine. 5 liters. Now, of course, I would take 6
I have now conducted an experiment: the same regime, the same amount of water.The ring has not yet changed in order to find the "culprit". It went bang without finishing the "porridge" regime. It flew out from under the cover: if you look at the stem on the front side, then on the left side.
now I will try all the same, but change the ring.
beverli
Mashul, how do you know when it's time to change the ring? How long does it last? Or wait until it blows
Chit
Quote: Margo31

It is no coincidence that on ozone 6L is cheaper than 5L. Or am I already finding fault
Masha, in the next topic, the temperature can not stand
By the way, I have a cartoon for 5 liters. I think the quality cannot be worse from the displacement.
Knor
Chit, so the culprit was found. Change the ring
Chit
Quote: Chubby

Chit, so the culprit was found. Change the ring
Yeah, now the steam will go down, let her rest. I will experiment again.
Masinen
Margarita, yes in different ways)
I have served for three years already, someone less.
It all depends)
beverli
unclear
Chit
Another experience: changed the ring,
pressure collected in 5 minutes
Steam went around the entire perimeter of the multi, there was no explosion.
Chit
Masinen, Maria, you are a "guru" in the way, tell me, please, can you twist something, press it down?
beverli
Chit, so maybe I inserted it wrong once the steam went off?
Chit
Quote: beverli

Chit, so maybe I inserted it wrong once the steam went off?
I do not know. I inserted it, scrolled it for reliability.
I think maybe the brackets on which the ring is pulled should be opened a little or ..?
beverli
Chit, oh, I am not an advisor in this matter ((((just if there was no pair before, but then I went along the entire perimeter, then it would be logical to assume that the ring was not inserted correctly.
beverli
Chit, and the ring has both sides the same? Maybe they just inserted the wrong side?
Chit
Quote: beverli

Chit, oh, I am not an advisor in this matter ((((just if there was no pair before, but then I went along the entire perimeter, then it would be logical to assume that the ring was not inserted correctly.
I do not know. Something I do not want to carry out the experiment again.
What to do next? Is the in-house cooking still paused?
beverli
Chit, Masha must wait
Chit
Quote: beverli

Chit, and the ring has both sides the same? Maybe they just inserted the wrong side?
Yes, it seems, they are the same, I never tried to put one side of a particular one.
Chit
Quote: beverli

Chit, Masha must wait
No exit. Without Masha nowhere
Margo31
Girls, what are you doing !!!!! Let the service conduct experiments, and you will be provided with a new staff! I would have understood about the experiments if she was no longer under warranty
Chit
Quote: Margo31

Girls, what are you doing !!!!! Let the service conduct experiments, and you will be provided with a new staff! I would have understood about the experiments if she was no longer under warranty
There was hope, suddenly, this is a "trifling" matter and it can be solved easily and simply. There are girls-veterans in the use of the staff, you never know who had such cases and they were solved once or twice. If everything is serious, then, of course, the road to service.
Margo31
Quote: Tiny

There was hope, suddenly, this is a "trifling" matter and it can be solved easily and simply. There are girls-veterans in the use of the staff, you never know who had such cases and they were solved once or twice. If everything is serious, then, of course, the road to service.
Maybe these were clinging to the lid somehow bent back and it has a very free move? And when you gain pressure, a gap appears, quite scanty
Chit
Quote: Margo31

Maybe these were clinging to the lid somehow bent back and it has a very free move?
I thought about that too. I don't want to climb myself, hook hands. I will wait for the advice of those in the know, then I will use physical strength.
beverli
How could they bend back on their own?
Chit
Quote: beverli

How could they bend back on their own?
Maybe the pressure has moved a little from the desired position, or when we take off and put on, I don't know. I could be wrong.
kolobashka
At first, the steam came out for me and even the pressure did not build up. I twisted the silicone ring, took it out, inserted it, tudy-syudy and it worked.
Chit
Quote: Kolobashka

At first, the steam came out for me and even the pressure did not build up. I twisted the silicone ring, took it out, inserted it, tudy-syudy and it worked.
I'll try again later. I'll twist the ring and start it. It is necessary to find the reason, but if this situation comes out with the products, it will turn out unpleasant
beverli
Chit, how are you?
Masinen
Margarita, here obviously, the ring did not sit down.

Try to put it on the other side.
Girls, it's also hard for me to judge when the multicooker is not in front of my nose.
I also let it sometimes, but this ring shifts.
Oddzhy was, like bang, but it looks a lot like a howl, and there was a problem in the lid, and not in the ring,
But then the multicooker was new.

I also advise you to remove the ring and the lid, wash well with detergent and wash the ring under the iron rim. Maybe somewhere there is fat left and the ring slips off.
beverli
What did you have with the lid? It is necessary to consider all possible options for such behavior multi ...
Chit
Quote: beverli

Chit, how are you?
I have not experienced it yet, we are doing our homework.
Chit
Quote: Masinen

Margarita, here obviously, the ring did not sit down.

Try to put it on the other side.
Girls, it's also hard for me to judge when the multicooker is not in front of my nose.
I also let it sometimes, but this ring shifts.
Oddzhy was, like bang, but it looks a lot like a howl, and there was a problem in the lid, and not in the ring,
But then the multicooker was new.

I also advise you to remove the ring and the lid, wash well with detergent and wash the ring under the iron rim. Maybe somewhere the fat remains and the ring slips off.
Maria, thank you for not passing by. I will use your advice, I hope it helps.
Oksanna
And I have a question about the hole in the lid. When the multicooker is gaining pressure, a hiss is heard from it and soars a little. The husband asked "what is she?"
I confidently declared "this is how it should be" and then I began to doubt something, on the first page it says about the black valve, but this hole seems not to be. They have already cooked the jellied meat, and have already eaten it ... but now, I think, I'll ask all the same
Masinen
It should soar correctly, and then the hole closes and everything is calm)
There is a float blocking the lid.

All recipes

New recipe

© Mcooker: best recipes.

map of site

We advise you to read:

Selection and operation of bread makers