NatalyTeo
Please teach me how to screw the multi-chopper correctly. I decided to try Kenwood nozzles
Olga VB
Quote: NatalyTeo

Please teach me how to screw the multi-chopper correctly. I decided to try out the Kenwood attachments
NatalyTeo, Natalia, in this case, the main thing is not to distort the base, otherwise the contents may spill out into the car.
A method that is good for a blender (turn it over and put the bowl on the table, and wind the base on top), for obvious reasons, will not work for a cartoon. So just try to keep both pieces horizontal, i.e. the glass on the table and the base parallel from above, - first, simply put the inner part of the base (with knives) on the glass, and then press the outer (threaded) one and make sure that the base is screwed on freely, without distortions, for one and a half or two full turns. For this, you can first twist a little in the opposite direction to catch the thread, and then tighten it.
If you are afraid, practice first on the water to understand how it should be twisted. Pour a little, twist, just turn and shake. If it twists freely and does not leak, then everything is fine.
Good luck!
NatalyTeo
Girls, thanks, I don't see the thank you button. I will train. Technically, I did just that, everything seemed to be smooth, I twist it well, turn it over and ... it leaks, I repeat the process. Maybe it's just that the new gum is not yet used to getting up in place the first time

All recipes

© Mcooker: best recipes.

map of site

We advise you to read:

Selection and operation of bread makers